Figure  Anlotinib chemical structure 9a shows Raman MLN2238 manufacturer Spectra measured, respectively, on a bare Ge(001) substrate, on a wire-covered substrate, and on an island-covered substrate after the shape change activated by Si deposition. Figure 7 Wire to dot transition. (a , b , c , d , e) STM images showing different stages of the wire-to-dot shape transition induced by Si deposition. The total Si content, obtained by Raman spectroscopy, is 10%. Table 1 Morphological parameters of wires and dots   Total volume [measured on a 4 × 4 μm 2image] (nm 3) Average height (nm) Average lateral size a(nm) Surface (S) to volume (V) ratioS/V 2/3 Wires (2.0 ± 0.5) × 107 18 ± 5 100 ± 10 10.3 Dots (1.8 ± 0.5) × 107

40 ± 5b 230 ± 10b 5.5     15 ± 5 130 ± 10   aThe width of the wires and the island edge size is reported. bDots show a bimodal distribution. Figure 8 Dot faceting. (a , b , c) STM images showing the morphology of the SiGe dots. In the inset of (c), the FP of the

corresponding image is reported. Figure 9 Raman spectroscopy. (a) Raman spectra of bare Ge(001) substrate, Ge wires, and SiGe islands formed from the wires with Si deposition. (b) Spectra extracted from the Raman image shown in (c). (c) Raman image. The color scale gives the intensity of the SiGe alloy peak at 399 cm-1. The markers highlight the position of the spectra reported in (b). (d) Composition image obtained from (c) by applying the relative-intensity method described in the text. As expected, the bare and the wire-covered substrate show

almost identical spectra in which the only feature is the Ge-Ge band located at about 300 cm-1. GS-4997 in vivo Conversely, the island-covered sample shows an extra peak at about 399 cm-1, being the Si-Ge alloy band. The band associated to the Si-Si mode cannot be detected, also within an extended energy range, as expected for low Si contents [24]. In fact, the Si content x, estimated by the relative intensities of the Ge-Ge and the Si-Ge bands [25], i.e., I Ge–Ge/I Si–Ge  = 1.6(1 - x)x -1, is x = 0.1. Therefore, a very small quantity of Si is indeed enough to drive the wire to island shape change. This can be only explained if the deposited Si does not cover the surface uniformly, but rather concentrates into the wires. In order to validate eltoprazine this hypothesis, we exploited Raman imaging. A complete spectrum is acquired at each and every pixel of the image, and then, a false color image is generated based on the intensity of the Si-Ge mode. Figure  9b shows two spectra extracted from the marked position on the Raman image displayed in panel c. In Figure  9d, we report the corresponding composition image obtained by the relative intensity method. As shown, the Si is totally absent from the substrate among the wires, whereas in the wires, it is intermixed with Ge. Besides, it can be seen how the brighter pixels, corresponding to Si-rich areas, exactly define the wire shape. Moreover, we also see many bright spots which are the dots forming along the wires.